SDS011 air quality sensor~
This feature is included only in tasmota-sensors.bin
Nova PM Sensor SDS011 can measure the air quality very accurately by measuring air particles or dust based on laser detection.
Specifications:
- Voltage: 4.7 - 5.3V DC (5V DC with <20mV ripple advised)
- Power consumption: 70mA ±10mA (in operation), <4mA (laser and fan sleep mode)
- Measuring range: 0.0-999.9 μg/m3
- PM2.5 and PM10 output
See manufacturer site for more information.
Configuration~
Wiring~
SDS011 | ESP8266 |
---|---|
GND | GND |
5V | 5V |
TX | GPIO RX |
RX | GPIO TX |
Tasmota Settings~
In the Configuration -> Configure Module page assign: 1. GPIO RX to SDS0X1 Tx (101)
2. GPIO TX to SDS0X1 Rx (70)
To extend the lifetime of the sensor, you can use the command Sensor20 in association with setting TelePeriod for how often you want the fan to run and the sensor to be polled.
Tasmota Main~
After reboot of the device the displays the SDS011 measurements.
OpenHab~
Number Dust_Sensor_2_5 "PM 2.5 [%.2f µg/m³]" <door> (Dust) {mqtt="<[mosquitto:tele/dust/SENSOR:state:JSONPATH($.SDS0X1['PM2.5'])]"}
Number Dust_Sensor_10 "PM 10 [%.2f µg/m³]" <door> (Dust) {mqtt="<[mosquitto:tele/dust/SENSOR:state:JSONPATH($.SDS0X1['PM10'])]"}