Skip to content

Changelog 7.2

Version 7.2.0 Constance~

  • Change Exception reporting removing exception details from Status 1 and consolidated in Status 12 if available
  • Change HTTP CORS from command SetOption73 0/1 to Cors <cors_domain> allowing user control of specific CORS domain by Shantur Rathore (#7066)
  • Change GUI Shutter button text to Up and Down Arrows based on PR by Xavier Muller (#7166)
  • Change amount of supported DHT sensors from 3 to 4 by Xavier Muller (#7167)
  • Change some Settings locations freeing up space for future single char allowing variable length text
  • Change tasmota-basic.bin and FIRMWARE_BASIC to tasmota-lite.bin and FIRMWARE_LITE
  • Fix flashing H801 led at boot by Stefan Hadinger (#7165, #649)
  • Fix duplicated Backlog when using Event inside a Backlog by Adrian Scillato (#7178, #7147)
  • Fix Gui Timer when using a negative zero offset of -00:00 by Peter Ooms (#7174)
  • Fix DeepSleep in case there is no wifi by Stefan Bode (#7213)
  • Fix Fade would ignore savedata 0 and store to flash anyways (#7262)
  • Fix Arduino IDE compile error (#7277)
  • Fix no AP on initial install (#7282)
  • Add command SerialConfig 0..23 or SerialConfig 8N1 to select Serial Config based in PR by Luis Teixeira (#7108)
  • Add command Sensor34 9 <weight code> to set minimum delta to trigger JSON message by @tobox (#7188)
  • Add rule var %topic% by Adrian Scillato (#5522)
  • Add rule triggers tele-wifi1#xxx by Adrian Scillato (#7093)
  • Add SML bus decoder syntax support for byte order by Gerhard Mutz (#7112)
  • Add experimental support for stepper motor shutter control by Stefan Bode
  • Add optional USE_MQTT_TLS to tasmota-minimal.bin by Bohdan Kmit (#7115)
  • Add save call stack in RTC memory in case of crash, command Status 12 to dump the stack by Stefan Hadinger
  • Add Home Assistant force update by Frederico Leoni (#7140, #7074)
  • Add Wifi Signal Strength in dBm in addition to RSSI Wifi Experience by Andreas Schultz (#7145)
  • Add Yaw, Pitch and Roll support for MPU6050 by Philip Barclay (#7058)
  • Add reporting of raw weight to JSON from HX711 to overcome auto-tare functionality by @tobox (#7171)
  • Add Zigbee support for Xiaomi Aqara Vibration Sensor and Presence Sensor by Stefan Hadinger
  • Add Shutter functions ramp up/down and MQTT reporting by Stefan Bode
  • Add fallback support from version 8.x
  • Add restriction if fallback firmware is incompatible with settings resulting in unreachable device
  • Add support for DHT12 Temperature and Humidity sensor by Stefan Oskamp