Skip to content

4CH Wifi Socket with USB Charger SA P402A

Products~

vierfachdose

Opening~

To open take a very small screwdriver to pull out the six feet. Don't remove the rubber plates, it won't help.

fuesschen

Flashing~

You'll have to connect GPIO0 manually, the switch is connected to GPIO1. It marked the pin in the picture. Because the TYWE2S has 2mm pitch, I made a little adapter to 2,54mm pitch. Then it can easy soldered to the first four pins. From left to right 3,3V, Gnd, Rx, Tx.

anschluss

Configuration~

Configure the USB-Charger as number five, then the next socket as number one and so on. This is the configuration:

configure module

  • For the other model (Koogeek and AOFO) the GPIO connections are a bit different:
  • LED: GPIO1
  • Switch: GPIO3
  • Socket 1: GPIO5
  • Socket 2: GPIO4
  • Socket 3: GPIO12
  • Socket 4: GPIO13
  • USB: GPIO14

  • For the model Woox R4028 the GPIO connections are a bit different ( only 3 EU Plugs):

  • LED: GPIO1
  • Switch: GPIO3
  • Socket 1: GPIO5
  • Socket 2: GPIO4
  • Socket 3: GPIO13
  • USB: GPIO14