BlitzWolf SHP7
Serial Connection~
Please see the Hardware Preparation page for general instructions.
Step 1~
Disconnect device from power source!
Step 2~
Remove the two stickers on the front.
Step 3~
Undo 2 screws. PH1 screwdriver required.
Step 4~
Remove back with screwdriver
Step 4~
Undo 2 screws at the back. PH1 screwdriver required.
Step 5~
Remove PCB from casing for easier soldering.
Step 6~
Solder cables to the ESP pins.
Because GND is hard to solder/access, I recommend to use the other side for GND:
Result:
Step 7~
Connect serial adapter and make a shortwire between Pin IO0 and GND during startup (for entering flashmode).
Step 8~
Flash Tasmota.
Step 9~
Setup Tasmota (wifi settings).
Go to Configuration -> Configure Other and enter this template: {"NAME":"SHP7 v2","GPIO":[18,158,56,131,134,132,0,0,17,57,21,0,22],"FLAG":0,"BASE":45} (I had to use v2 from https://templates.blakadder.com/blitzwolf_SHP7.html)
Done !